COM & COL for Custom Furniture: Yardage, Dye Lots and Approval Risks
Understand COM/COL upholstery requirements including usable width, repeat, orientation, dye lots, cutting approvals, leather yield and shortage risk. Put the approved lot and retained sample on the sample approval form so a second cut is judged against the same reference, and state the allowance in the dimensional limits.
COM and COL shift material selection to the buyer or designer, but the factory still needs production-ready information. Before cutting, confirm usable width, repeat, orientation, pattern matching, allowance, trim or welt requirements, dye-lot or cutting-for-approval expectations and material arrival. Leather needs a separate yield discussion because hide shape, defects and usable area differ from roll goods.
01
Make the decision in this order
Confirm whether the cover is COM or COL
Calculate from usable width, repeat and orientation
Agree pattern matching and cutting direction
Define dye-lot or cutting-for-approval control
Plan shortage, reorder and material-arrival risk
02
What the specification or approval should record
Supplier, article, colour and lot
Usable width or hide size and yield basis
Vertical and horizontal repeat
Railroaded or up-the-roll direction
Welt, piping, contrast panels and matching rules
Shipment quantity, reserve and release-to-cut approval
03
Evidence before claim
Use supplier technical data, an upholstery cutting plan where risk is high and a traceable approval before cutting.
Claim boundary: There is no single waste percentage for every pattern, width or leather hide.
Before reserving a fabric lot, use the upholstery fabric quantity estimate for an initial allowance. Ask the upholsterer to confirm usable width, repeat, cutting layout and final order quantity.
What the project team should decide: COM & COL for Custom Furniture: Yardage & Approval Guide
Start with the end use and project jurisdiction. Abrasion, flammability, colourfastness, cleanability, seam behaviour and visual character answer different questions; one test number cannot stand in for the whole upholstery decision.
Decision
Design/owner view
Procurement/technical view
End use
Touch, drape, colour, pattern scale and desired atmosphere
Upholstery, panel or drapery use; traffic, cleaning and destination requirements
Performance
What ageing or variation remains acceptable
Applicable test method, report identity, sample condition and limitations
COM/COL control
Approved face, direction and seam expression
Usable width, repeat, flaws, yield, cutting allowance and batch identity
Release
Strike-off, cutting or completed-item review required
Approval status, retained sample, substitution route and production lot
Bring to the review
Latest drawing or rendering, quantities, intended use, destination, material references, current quotation assumptions and unresolved comments.
Keep after the review
Approved revision, sample identity, decision limits, exceptions, responsible party and the evidence required before the next release.
Can two suppliers quote the same material name and still offer different quality?
Yes. Substrate, grade, thickness, finish build, hardware, fabrication and approval basis can differ. Compare the complete build-up and sample route.
What should be approved before bulk production?
Approve the drawing revision and the sample level appropriate to the risk: material or finish reference, prototype, mock-up or first-production piece.